Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › COMPRESSION › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356050 COMPRESSION A

14B ENGINE MECHANICAL  COMPRESSION  CHECK  


CAUTION / NOTICE / HINT

HINT:

If there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.


PROCEDURE

Hide 1.WARM UP AND STOP ENGINE

a.

Allow the engine to warm up to normal operating temperature.


Hide 2.REMOVE INJECTION NOZZLES

Hide 3.DISCONNECT INJECTION PUMP (FUEL CUT SOLENOID) CONNECTOR

Hide 4.CHECK CYLINDER COMPRESSION PRESSURE

a.
A420934

Install the gasket and SST (attachment) to the injection nozzle hole with the 2 nuts.

SST
09992-19015  (09992-10060)

Torque:

18 N*m (184 kgf*cm, 13 ft.*lbf)



b.
A420935

Connect SST (compression gauge) to the SST (attachment).

SST
09992-19015  (09992-10010, 09992-10040, 09992-10060)


c.

Fully open the throttle valve, and start the engine.


d.

While cranking the engine, measure the compression pressure.

HINT:

Always use a fully charged battery to obtain engine revolution of 250 rpm or more.



e.

Repeat steps (a) through (d) for each cylinder.

NOTICE:

This measurement must be done in as short a time as possible.


Compression pressure:

2,942 kPa (30.0 kgf/cm2, 427 psi) or more


Minimum pressure:

1,961 kPa (20.0 kgf/cm2, 284 psi)


Difference between each cylinder:

196 kPa (2.0 kgf/cm2, 28 psi) or less