Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › CYLINDER BLOCK › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356054 CYLINDER BLOCK A

14B ENGINE MECHANICAL  CYLINDER BLOCK  PISTON AND CONNECTING ROD DISASSEMBLY  


PROCEDURE

Hide 1.CHECK FIT BETWEEN PISTON AND PISTON PIN

a.
A420993

Try to move the piston back and forth on the piston pin.

If any movement is felt. replace the piston and pin as a set.


Hide 13011 2.REMOVE PISTON RINGS

a.
A420994

Using a piston ring expander, remove the No.1, No.2 and oil rings.


b.

Remove the coil by hand.

HINT:

Arrange the rings in correct order only.



Hide 3.DISCONNECT CONNECTING ROD FROM PISTON

a.
A420995

Using needle-nose pliers, remove the snap rings.


b.
A420996

Gradually heat the piston to approx. 60° C (140° F).


c.

Using a plastic-faced hammer and brass bar, lightly tap out the piston pin and remove the connecting rod.

HINT:
·

The piston and pin are a matched set.

·

Arrange the pistons, pins, rings, connecting rods and bearings in correct order.