Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › CYLINDER BLOCK › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356054 CYLINDER BLOCK A

14B ENGINE MECHANICAL  CYLINDER BLOCK  CRANKSHAFT OIL SEAL REPLACEMENT  


CAUTION / NOTICE / HINT

HINT:

There are 2 methods (A and B) to replace the oil seal which are as follows:


PROCEDURE

Hide 1.REPLACE CRANKSHAFT REAR OIL SEAL

a.
A424162

If rear oil seal retainer is removed from cylinder block:

i.

Using a screwdriver and hammer, tap out the oil seal.


ii.
A424163

Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.

SST
09223-56010  


iii.

Apply MP grease to the oil seal lip.



b.
A424164

If rear oil seal retainer is installed to cylinder block:

i.

Using a knife, cut off the oil seal lip.


ii.

Using a screwdriver, pry out the oil seal.

NOTICE:

Be careful not to damage the crankshaft. Tape the screwdriver tip.



iii.

Apply MP grease to a new oil seal lip.


iv.
A424165

Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

SST
09223-56010