Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › CYLINDER BLOCK › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356054 CYLINDER BLOCK A

14B ENGINE MECHANICAL  CYLINDER BLOCK  PISTON AND CONNECTING ROD ASSEMBLY  


PROCEDURE

Hide 1.ASSEMBLE PISTON AND CONNECTING ROD

a.
A424166

Install a new snap ring on one side of the piston pin hole.


b.

Gradually heat the piston to 60° C (140° F).


c.

Coat the piston pin with engine oil.


d.
A424167

Align the front marks of the piston and connecting rod, and push in the piston pin with your thumb.


e.

Install a new snap ring on the other side of the piston pin hole.


Hide 13011 2.INSTALL PISTON RINGS

a.
A424168

Install the coil by hand.


b.

Install a piston ring expander, install the oil ring.

HINT:
A424169

Face the end gap of the oil ring in the opposite direction of coil joint.



c.

Using a piston ring expander, install the No.1 and No.2 piston rings with the code mark facing upward.

Code mark:
No.1:

T (3B, 14B) or 1T (15B-F, 15B-FT)

No.2:

2T (3B) or T2 (14B, 15B-F, 15B-FT)



d.
A424171

Position the piston rings so that the ring ends are as shown.

NOTICE:

Do not align the ring ends.



Hide 3.INSTALL CONNECTING ROD BEARINGS

a.
A424172

Align the bearing claw with the groove of the connecting rod or connecting rod cap.


b.

Install the bearings in the connecting rod and connecting rod cap.