Home › Engine / Hybrid System › 14B (ENGINE MECHANICAL) › IDLE SPEED AND MAXIMUM SPEED › 2017.01–2019.08
RM2850E _51 Engine / Hybrid System _073170 14B ENGINE MECHANICAL _0356055 IDLE SPEED AND MAXIMUM SPEED A

14B ENGINE MECHANICAL  IDLE SPEED AND MAXIMUM SPEED  INSPECTION AND ADJUSTMENT  


PROCEDURE

Hide 1.INSTALL CONDITIONS

a.

Engine at normal operating temperature


b.

Air cleaner installed


c.

All accessories switched OFF


d.

All vacuum lines properly connected


e.

Valve clearance set correctly


f.

Injection timing set correctly


g.

w/ PS Idle-Up System:

Steering wheel at straight-ahead position


Hide 2.CONNECT TACHOMETER

Hide 3.INSPECT AND ADJUST IDLE SPEED

a.
A429051

Check that the adjusting lever touches the idle speed adjusting screw when the accelerator pedal is released.

If not, adjust the accelerator linkage.


b.

Start the engine.


c.

Check the idle speed.

Idle speed:
3B:

600 - 700 rpm

14B:

750 - 850 rpm

14B (Except Hong Kong):

600 - 700 rpm

15B-F, 15B-FT:

700 - 750 rpm



d.

Adjust the idle speed.

·

Disconnect the accelerator linkage.

·

Loosen the lock nut of the idle speed adjusting screw.

·

Adjust the idle speed by turning the idle speed adjusting screw.

·

Securely tighten the lock nut, and recheck the idle speed.

·

Reconnect the accelerator linkage.

·

After adjustment, adjust the accelerator linkage.



Hide 4.CHECK MAXIMUM SPEED

a.
A429052

Check that the adjusting lever touches the maximum speed adjusting screw when the accelerator pedal is depressed all the way.

If not, adjust the accelerator linkage.


b.

Start the engine.


c.

Depress the accelerator pedal all the way.


d.

Check the maximum speed.

Maximum speed:
3B:

4,050 - 4,200 rpm

14B:

4,050 - 4,250 rpm

15B-F, 15B-FT:

3,900 - 4,100 rpm



e.
A429053

Adjust the idle speed.

·

Disconnect the accelerator linkage.

·

Cut off the seal wire of the maximum speed adjusting screw.

·

w/ HAC, 15B-FT:

Using SST, loosen the lock nut of the maximum speed adjusting screw.


SST
09275-54020  

·

Others:

Loosen the lock nut of the maximum speed adjusting screw.

·

Adjust the maximum speed by turning the maximum speed adjusting screw.


HINT:

Adjust at idle speed. Then, raise engine speed and recheck the maximum speed.


·

w/ HAC, 15B-FT:

Using SST, securely tighten the lock nut.


SST
09275-54020  

·

Others:

Securely tighten the lock nut.

·

Recheck the maximum speed.

·

Reconnect the accelerator linkage.

·

After adjustment, adjust the accelerator linkage.

·
A429054

Seal the maximum speed adjusting screw with a new seal wire.