1.REMOVE DUST PROTECTOR
2.REMOVE LEAD WIRE
Remove the screw and lead wire from terminal 50.
3.REMOVE FIELD FRAME WITH ARMATURE FROM MAGNETIC SWITCH ASSEMBLY
Remove the nut, disconnect the lead wire from terminal C and remove the plate washer.
Remove the 2 through bolts.
Pull out the field frame together with the armature from the magnetic switch assembly.
Remove the felt washer.
4.REMOVE STARTER HOUSING, CLUTCH ASSEMBLY AND GEARS
Remove the 3 screws and starter housing.
Remove these parts from the magnetic switch assembly:
Clutch assembly
Return spring
Idler gear
Bearing
Plate washer
5.REMOVE STEEL BALL
Using a magnetic finger, remove the steel ball from the clutch shaft hole.
28140
6.REMOVE BRUSH HOLDER
Remove the 2 screws and end cover from the field frame.
Using a screwdriver, hold the spring tank back and disconnect the brush from the brush holder.
Disconnect the 4 brushes and remove the brush holder.
7.REMOVE ARMATURE FROM FIELD FRAME