1.DISCONNECT PRE-HEATING TIMER CONNECTOR
LOCATION: See relay locations in Electrical Wiring Diagram.
2.INSPECT PRE-HEATING TIMER CIRCUIT
Check the connector on the wire harness side as shown in these chart:
| Check for | Tester connection | Condition | Specified value |
|---|---|---|---|
| Voltage | G-IND - Ground | Ignition switch OFF | No voltage |
| Ignition switch ON | Battery voltage | ||
| Voltage | IG - Ground | Ignition switch OFF | No voltage |
| Ignition switch ON | Battery voltage | ||
| Continuity | G-REL - Ground | - | Continuity |
| Continuity | THW, EG - Ground | - | Continuity |
3.RECONNECT PRE-HEATING TIMER CONNECTOR