LOCATION: See relay locations in Electrical Wiring Diagram.
1.REMOVE STARTER RELAY (BU)
2.INSPECT STARTER RELAY (BU)
Inspect relay continuity
Using an ohmmeter, check that there is continuity between terminals 1 and 2.
Check that there is no continuity between terminals 3 and 4.
If continuity is not as specified, replace the relay.
Inspect relay operation
Apply battery voltage across terminals 1 and 2.
Using an ohmmeter, check that there is continuity between terminals 3 and 4.
If operation is not as specified, replace the relay.
3.REINSTALL STARTER RELAY (BU)
4.REMOVE STARTER RELAY (BB)
5.INSPECT STARTER RELAY (12V) (BB)
Inspect relay continuity
Using an ohmmeter, check that there is continuity between terminals 3 and 4.
Check that there is no continuity between terminals 1 and 2.
If continuity is not as specified, replace the relay.
Inspect relay operation
Apply battery voltage across terminals 3 and 4.
Using an ohmmeter, check that there is continuity between terminals 1 and 2.
If operation is not as specified. replace the relay.
6.INSPECT STARTER RELAY (24V) (BB)
Inspect relay continuity
Using an ohmmeter, check that there is continuity between terminals 1 and 2.
Check that there is no continuity between terminals 3 and 4.
If continuity is not as specified, replace the relay.
Inspect relay operation
Apply battery voltage across terminals 1 and 2.
Using an ohmmeter, check that there is continuity between terminals 3 and 4.
If operation is not as specified. replace the relay.
7.REINSTALL STARTER RELAY (BB)