Home › Engine / Hybrid System › N04C-UH (ENGINE MECHANICAL) › CAMSHAFT
RM2850E _51 Engine / Hybrid System _073174 N04C-UH ENGINE MECHANICAL _0356073 CAMSHAFT G

N04C-UH ENGINE MECHANICAL  CAMSHAFT  INSPECTION  


PROCEDURE

Hide 13501 1.INSPECT CAMSHAFT

a.
A151553

Inspect the camshaft for circle runout.

i.

Place the camshaft on V-blocks.


ii.

Using a dial gauge, measure the circle runout at the center journal.

Maximum Circle Runout:

0.06 mm (0.00236 in.)


If the circle runout is greater than the maximum, replace the camshaft.



b.

Using a micrometer, measure the cam lobe height.

Standard Cam Lobe Height:
Intake Side:

50.66 to 50.86 mm (1.9945 to 2.0024 in.)

Exhaust Side:

49.36 to 49.56 mm (1.9433 to 1.9512 in.)


Minimum Cam Lobe Height:
Intake Side:

50.20 mm (1.9764 in.)

Exhaust Side:

48.95 mm (1.9272 in.)


If the lobe height is less than the minimum, replace the camshaft.