Home › Engine / Hybrid System › N04C-UH (ENGINE MECHANICAL) › DRIVE BELT
RM2850E _51 Engine / Hybrid System _073174 N04C-UH ENGINE MECHANICAL _0356074 DRIVE BELT G

N04C-UH ENGINE MECHANICAL  DRIVE BELT  INSPECTION  


PROCEDURE

Hide 1.INSPECT V BELT

a.
A101818

Check the belt for wear, cracks and other signs of damage.

If any defects are found, replace the V belt.

HINT:
Replace the drive belt if any of the following defects are found:
·

The belt is worn out and the wire is exposed.

·

The cracks reach the wire in more than one place.




b.

Check that the belt fits properly into the grooves.

HINT:

Confirm by hand that the belt has not slipped out of the grooves on the bottom of the pulley.