1.INSTALL STUD BOLT
| *A | Intake Manifold Side | *B | Exhaust Manifold Side |
Using "TORX" socket wrenches E10 and E8, install the stud bolts.
25 N*m (255 kgf*cm, 18 ft.*lbf)
51 N*m (520 kgf*cm, 38 ft.*lbf)
2.INSTALL VALVE STEM OIL SHIELD
Apply a light coat of engine oil to the valve guide bush.
Using SST, install the valve stem oil shield.
After attaching the valve stem oil shield, check that there are no deformations, cracks, or slants to the rubber sections.
After attaching the valve stem oil shield, check that the valve stem oil shields are seated properly and that they are at a certain depth.
If there are any foreign objects within the valve or valve guide, the valve stem oil shield will become damaged. Check for any soiling or foreign objects before inserting the valve.
After attaching, check the attachment height of the valve stem oil shield.
| *a | 29.0 to 29.5 mm (1.142 to 1.161 in.) |
13711
3.INSTALL INTAKE VALVE
Apply engine oil to the valve tip.
Install the valve, inner compression spring and valve spring retainer.
Install the parts in their original locations.
Using SST, compress the inner compression spring and place the 2 valve spring retainer locks around the valve stem.
Using a pin punch 5, lightly tap the valve stem tip to ensure a proper fit.
Be careful not to damage the valve stem tip.
13715
4.INSTALL EXHAUST VALVE
Apply engine oil to the valve tip.
Install the valve, inner compression spring and valve spring retainer.
Install the parts in their original locations.
Using SST, compress the inner compression spring and place the 2 valve spring retainer locks around the valve stem.
Using a pin punch 5, lightly tap the valve stem tip to ensure a proper fit.
Be careful not to damage the valve stem tip.