Home › Engine / Hybrid System › N04C-UH (FUEL) › FUEL SYSTEM
RM2850E _51 Engine / Hybrid System _073175 N04C-UH FUEL _0356077 FUEL SYSTEM G

N04C-UH FUEL  FUEL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FOR FUEL PRESSURE

a.

Read the Data List.

i.

Warm up the engine.


ii.

Turn the ignition switch off.


iii.

Connect the intelligent tester to the DLC3.


iv.

Start the engine.


v.

Turn the intelligent tester on.


vi.

Enter the following menus: Powertrain / Engine and ECT / Data List.


vii.

Read the Data List.

Intelligent Tester Display Measurement: Range (Display) Normal Condition
Fuel Press Fuel pressure: Min.: 0 kPa, Max.: 655350 kPa Idling: 25000 to 35000 kPa



Hide 2.INSPECT FOR FUEL LEAK

a.

Perform the Active Test.

i.

Connect the intelligent tester to the DLC3.


ii.

Start the engine.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Active Test.


v.

Perform the Active Test.

Intelligent Tester Display Test Details Control Range Diagnostic Notes
Test the Fuel Leak Pressurizing common rail internal fuel pressure, and checking for fuel leaks Stop/Start
·

Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when Start is selected

·

Above conditions to be maintained while test is Start