Home › Engine / Hybrid System › N04C-UH (FUEL) › FUEL SUPPLY PUMP
RM2850E _51 Engine / Hybrid System _073175 N04C-UH FUEL _0356079 FUEL SUPPLY PUMP G

N04C-UH FUEL  FUEL SUPPLY PUMP  INSPECTION  


PROCEDURE

Hide 22100 1.INSPECT INJECTION OR SUPPLY PUMP ASSEMBLY

a.

Check the suction control valve.

i.
A159437E02
1.497,0.637 0.872,0.383 false 1.548,0.601 0.881,0.19 false 0.721,0.306 0.873,0.481 0.153,0.175 10 1 0.721,0.061 0.873,0.236 0.153,0.175 10 2 2.071,0.121 2.224,0.277 0.153,0.155 10 *1 0.148,0.131 0.307,0.288 0.159,0.157 10 *a 1.712,0.313 2.032,0.213 false

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*1 Suction Control Valve
*a Component without harness connected
(Injection or Supply Pump Assembly)

Standard Resistance:
Tester Connection Condition Specified Condition

If the resistance is not as specified, replace the fuel supply pump.

1 - 2 20°C (68°F) 1.9 to 2.3 Ω




b.

Check the fuel temperature sensor.

i.
A430814E01
1.031,2.094 1.188,2.292 0.156,0.198 10 false .

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*a Resistance
*b Temperature
*c Component without harness connected
(Injection or Supply Pump Assembly)

Standard Resistance:
Tester Connection Condition Specified Condition

If the resistance is not as specified, replace the fuel supply pump.

1 - 2 20°C (68°F) 2.21 to 2.69 kΩ
1 - 2 80°C (176°F) 0.287 to 0.349 kΩ