23300J
1.REMOVE FUEL FILTER ASSEMBLY
Disconnect the 2 connectors and 2 harness clamps.
Disconnect the 2 fuel hoses.
Disconnect the 2 fuel heater hoses (w/ fuel heater).
Remove the 2 bolts and the fuel filter assembly.
2.DRAIN FUEL
Loosen the drain plug, then drain the fuel from the fuel filter.
Tighten the drain plug.
84461B
3.REMOVE LEVEL WARNING SWITCH
Clamp the fuel filter in a soft jaw vise.
Using pliers, remove the level warning switch.
Do not damage the level warning switch.
Remove the O-ring from the fuel level warning switch.
23303
4.REMOVE FUEL FILTER ELEMENT SUB-ASSEMBLY
Using SST, remove the fuel filter element.
23303
5.INSTALL FUEL FILTER ELEMENT SUB-ASSEMBLY
Check and clean the fuel filter installation surface.
Apply fuel to the gasket of a new fuel filter element.
Lightly screw the fuel filter element into place, and tighten it until the gasket comes into contact with the seat.
Tighten it an additional 3/4 turn by hand.
84461B
6.INSTALL LEVEL WARNING SWITCH
Install a new O-ring to the level warning switch.
Apply fuel to the O-ring of the level warning switch.
Install the level warning switch to the fuel filter and tighten it by hand.
23300J
7.INSTALL FUEL FILTER ASSEMBLY
Install the fuel filter with the 2 bolts.
18 N*m (179 kgf*cm, 13 ft.*lbf)
Connect the 2 fuel heater hoses (w/ fuel heater).
Connect the 2 fuel hoses.
Connect the level warning switch connector and 2 harness clamps.
8.RESET FUEL SYSTEM WARNING LIGHT
Turn the ignition switch to ON.
After turning the ignition switch to ON, connect the clogging switch connector within 3 to 60 seconds.
Check that the combination meter's fuel system warning light turns off.
9.BLEED AIR FROM FUEL SYSTEM
Using the hand pump, bleed air from the fuel system until pumping becomes difficult.
10.INSPECT FOR FUEL LEAK