Home › Engine / Hybrid System › N04C-UH (FUEL) › FUEL SENDER GAUGE ASSEMBLY
RM2850E _51 Engine / Hybrid System _073175 N04C-UH FUEL _0356083 FUEL SENDER GAUGE ASSEMBLY G

N04C-UH FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAGE ASSEMBLY

a.
A399344E01
1.719,0.563 1.531,0.188 1.531,0.188 1.365,0.188 false 2.24,0.177 2.073,0.177 2.073,0.177 1.948,0.552 false 0.094,0.073 0.406,0.271 0.313,0.198 10 false *a 2.198,1.719 2.51,1.917 0.313,0.198 10 false *b 1.135,0.115 1.365,0.323 0.229,0.208 10 false FE 2.302,0.094 2.531,0.302 0.229,0.208 10 false FV

Check the fuel sender gauge voltage.

i.

Apply 5 V between terminals 1 (FV) and 2 (FE).

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (FV) and 2 (FE).



Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Battery

HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.



ii.
A399345E04
0.354,2.073 1.021,2.073 false 0.292,0.708 0.708,0.708 true 1,0.771 1,1.271 true 0.573,4.375 1.156,4.375 false 0.083,0.083 0.396,0.281 0.313,0.198 10 false *a 1.073,1.99 1.25,2.188 0.177,0.198 10 false F 0.438,4.292 0.615,4.49 0.177,0.198 10 false E 0.906,1.302 1.135,1.5 0.229,0.198 10 false FE 0.063,0.635 0.292,0.833 0.229,0.198 10 false FR

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

*: The output voltage changes depending on the voltage applied to the terminals.

2 (FE) - 3 (FR) Float position is F (upper) 4.255 to 4.605 V*
Float position is E (lower) 0.345 to 0.695 V*


Text in Illustration
*a Component without harness connected
(Fuel Sender Gauge Assembly)

HINT:
·

Output voltage (F) = (0.851 x Voltage applied to terminals) to (0.921 x Voltage applied to terminals)

·

Output voltage (E) = (0.069 x Voltage applied to terminals) to (0.139 x Voltage applied to terminals)



If the result is not as specified, replace the fuel sender gauge assembly.