1.INSPECT EGR VALVE ASSEMBLY
Inspect the EGR solenoid valve.
| *a | Component without harness connected
(EGR Valve Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the EGR valve. |
||
| 1 (EGR) - 5 (+B) | 20°C (68°F) | 6.5 to 7.5 Ω |
Inspect the EGR valve lift sensor.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the EGR valve. |
||
| 2 (E2) - 3 (VC) | 20°C (68°F) | 2.45 to 4.55 kΩ |