Home › Engine / Hybrid System › N04C-UH (EMISSION CONTROL) › EXHAUST GAS TEMPERATURE SENSOR
RM2850E _51 Engine / Hybrid System _073176 N04C-UH EMISSION CONTROL _0356088 EXHAUST GAS TEMPERATURE SENSOR A

N04C-UH EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89425 1.INSTALL EXHAUST GAS TEMPERATURE SENSOR

a.

Using a union nut wrench (14 mm), install the exhaust gas temperature sensor onto the center exhaust pipe assembly.

Torque:

30 N*m (306 kgf*cm, 22 ft.*lbf)


NOTICE:
·

Refer to the torque above when not using the union nut wrench. When using the union nut wrench, calculate the torque in accordance with the lengths of the union nut wrench and the torque wrench.

·

Do not damage the exhaust gas temperature sensor.




b.

Connect the exhaust gas temperature sensor connector.


Hide 89425A 2.INSTALL NO. 2 EXHAUST GAS TEMPERATURE SENSOR

a.

Using a union nut wrench (14 mm), install the No. 2 exhaust gas temperature sensor onto the center exhaust pipe assembly.

Torque:

30 N*m (306 kgf*cm, 22 ft.*lbf)


NOTICE:
·

Refer to the torque above when not using the union nut wrench. When using the union nut wrench, calculate the torque in accordance with the lengths of the union nut wrench and the torque wrench.

·

Do not damage the exhaust gas temperature sensor.




b.

Connect the No. 2 exhaust gas temperature sensor connector and 2 harness clamps.