Home › Engine / Hybrid System › N04C-UH (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR
RM2850E _51 Engine / Hybrid System _073176 N04C-UH EMISSION CONTROL _0356090 DIFFERENTIAL PRESSURE SENSOR G

N04C-UH EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89480A 1.INSPECT DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / DPNR Differential Pressure.


e.

Using pliers, grip the claws of the clip and slide the clip to disconnect the exhaust pipe air hose (vehicle front side) from the sensor.


f.
A146674

Using SST (turbo pressure gauge), apply pressure to the sensor.

SST
09992-00242  


g.

Check the pressure value of the sensor.

OK:

Approximately the same pressure as the applied pressure is indicated.


NOTICE:

Perform the inspection within the pressure range of 0 kPa to 98 kPa.


If the result is not as specified, check the sensor circuit.


h.

Remove the SST.


i.

Using pliers, grip the claws of the clip and slide the clip to connect the exhaust pipe air hose (vehicle front side).