1.INSPECT FOR COOLANT LEAK
Remove the radiator cap sub-assembly.
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator assembly.
Fill the radiator assembly with coolant and attach a radiator cap tester.
| *a | Radiator Cap Tester |
Warm up the engine.
Pump it to 137 kPa (1.4 kgf/cm2, 19.9 psi), then check that the pressure does not drop.
If the pressure drops, check the hoses, radiator assembly and engine water pump assembly for leakage. If there are no signs of external coolant leakage, check the heater core, cylinder block and head.
Reinstall the radiator cap sub-assembly.
2.CHECK COOLANT LEVEL OF RESERVOIR
The engine coolant should be between the LOW and FULL lines when the engine is cold.
If low, check for leakage and add Toyota Super Long Life Coolant or similar high quality ethylene glycol based non-silicate, non-amine, non-nitrite, and non-borate coolant with long-life hybrid organic acid technology up to the FULL line.
3.CHECK ENGINE COOLANT QUALITY
Remove the radiator cap sub-assembly.
To avoid the danger of being burned, do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.
Check for any excessive deposits of rust or scale around the radiator cap sub-assembly and radiator filler hole; the coolant should be free of oil.
If excessively dirty, replace the coolant.
Reinstall the radiator cap sub-assembly.