Replace the inner and outer races with new ones as a set only if the outer races of the bearings are removed.
| Applicable Parts | Outer Race Removal and Installation Procedure | Reusable/Non-reusable
(Replace the inner and outer races as a set.) |
|---|---|---|
| Front axle hub inner bearing | Procedure performed | Non-reusable |
| Procedure not performed | Reusable | |
| Front axle hub outer bearing | Procedure performed | Non-reusable |
| Procedure not performed | Reusable |
1.REMOVE OIL SEAL AND BEARING
Using SST, remove the oil seal.
Remove the bearing from the axle hub.
2.REMOVE BEARING OUTER RACES
Using a brass bar and hammer, remove the inside bearing outer race.
w/ ABS:
Be careful not to damage the ABS speed sensor rotor.
Employ the same manner described above to the outer side.
3.REMOVE BRAKE DRUM OR DISC
Place the matchmarks on the drum/disc and axle hub.
Remove the 5 bolts and drum/disc.