Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM2850E _52 Drivetrain _073182 AXLE AND DIFFERENTIAL _0356115 FRONT AXLE HUB A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:

Replace the inner and outer races with new ones as a set only if the outer races of the bearings are removed.

Applicable Parts Outer Race Removal and Installation Procedure Reusable/Non-reusable
(Replace the inner and outer races as a set.)
Front axle hub inner bearing Procedure performed Non-reusable
Procedure not performed Reusable
Front axle hub outer bearing Procedure performed Non-reusable
Procedure not performed Reusable


PROCEDURE

Hide 1.INSTALL BRAKE DRUM OR DISC

a.
C396686

Align the matchmarks on the drum/disc and axle hub.


b.

Install the axle hub and 5 bolts.

Torque:

170 N*m (1,700 kgf*cm, 125 ft.*lbf)



Hide 2.INSTALL BEARING OUTER RACES

a.
C396676

Using SST and a press, install a new outside bearing outer race.

SST

SST
09950-60021  (09951-00710)

SST
09950-70010  (09951-07150)


b.

Using SST and a press, install a new inside bearing outer race.

SST

SST
09950-60021  (09951-00710)

SST
09950-70010  (09951-07150)

NOTICE:

w/ ABS:

Be careful not to damage the ABS speed sensor rotor.



Hide 3. PACK BEARING WITH MP GREASE

a.
C396677

Place MP grease in your palm.


b.

Pack grease into the bearing, continuing until the grease oozes out from the other side.


c.

Employ the same manner around the bearing circumference.


Hide 4. COAT INSIDE OF AXLE HUB AND GREASE CAP WITH MP GREASE

C396678

Hide 5.INSTALL INNER BEARING AND NEW OIL SEAL

a.

Place the inner bearing into the axle hub.


b.
C396679

Using SST and hammer, install a new oil seal.

SST
09218-56030  09950-70010  (09951-07150)

NOTICE:

w/ ABS:

Be careful not to damage the ABS speed sensor rotor.



c.

Coat the lip of the oil seal with MP grease.