Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM2850E _52 Drivetrain _073182 AXLE AND DIFFERENTIAL _0356118 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:

Replace the inner and outer races with new ones as a set only if the outer races of the bearings are removed.

Applicable Parts Outer Race Removal and Installation Procedure Reusable/Non-reusable
(Replace the inner and outer races as a set.)
Rear axle hub inner bearing Procedure performed Non-reusable
Procedure not performed Reusable
Rear axle hub outer bearing Procedure performed Non-reusable
Procedure not performed Reusable


PROCEDURE

Hide 1.REMOVE OIL SEAL AND BEARING

a.
C396732

Using SST, remove the oil seal.

SST
09308-00010  


b.

Remove the plate and inner bearing.


Hide 2.REMOVE BEARING OUTER RACES

a.
C396733

Using a brass bar and hammer, remove the inside bearing outer race.

NOTICE:

w/ ABS:

Be careful not to damage the ABS speed sensor rotor.



b.

Employ the same manner described above to the outer side.


Hide 42403 3.REMOVE BRAKE DRUM

a.
C396734

Place the matchmarks on the brake drum and axle hub.


b.

Remove the 5 bolts and drum.