Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB
RM2850E _52 Drivetrain _073182 AXLE AND DIFFERENTIAL _0356118 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:

Replace the inner and outer races with new ones as a set only if the outer races of the bearings are removed.

Applicable Parts Outer Race Removal and Installation Procedure Reusable/Non-reusable
(Replace the inner and outer races as a set.)
Rear axle hub inner bearing Procedure performed Non-reusable
Procedure not performed Reusable
Rear axle hub outer bearing Procedure performed Non-reusable
Procedure not performed Reusable


PROCEDURE

Hide 42403 1.INSTALL BRAKE DRUM

a.
C396735

Align the matchmarks on the brake drum and axle hub.


b.

Install the axle hub and 5 bolts.

Torque:

170 N*m (1,700 kgf*cm, 125 ft.*lbf)



Hide 2.INSTALL BEARING OUTER RACES

a.
C396736

Using SST and a press, install a new outside bearing outer race.

SST
09255-10012  09950-70010  (09951-07150)


b.

Using SST and a press, install a new inside bearing outer race.

SST

09550-55011 (09550-05051)

SST
09950-70010  (09951-07150)

NOTICE:

w/ ABS:

Be careful not to damage the ABS speed sensor rotor.



Hide 3. PACK BEARING WITH MP GREASE

a.
C396737

Place MP grease in your palm.


b.

Pack grease into the bearing continuing until the grease oozes out from the other side.


c.

Employ the same manner around the bearing circumference.


Hide 4. COAT INSIDE OF AXLE HUB WITH MP GREASE

C396738

Hide 5.INSTALL INNER BEARING AND NEW OIL SEAL

a.

Place the inner bearing and plate into the axle hub.


b.
C396739

Using SST, steel plate and hammer, install a new oil seal.

SST
09570-24011  

NOTICE:

w/ ABS:

Be careful not to damage the ABS speed sensor rotor.