Home › Drivetrain › AXLE AND DIFFERENTIAL › DIFFERENTIAL CARRIER ASSEMBLY
RM2850E _52 Drivetrain _073182 AXLE AND DIFFERENTIAL _0356119 DIFFERENTIAL CARRIER ASSEMBLY A

AXLE AND DIFFERENTIAL  DIFFERENTIAL CARRIER ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 41204 1.REMOVE COMPANION FLANGE

a.
C397045

Using a hammer and chisel, loosen the staked part of the nut.


b.
C397046

Using SST to hold the flange, remove the nut.

SST
09330-00021  


c.
C397047

Using SST, remove the companion flange.

SST
09950-40011  


Hide 2.REMOVE FRONT OIL SEAL AND OIL SLINGER

a.
C397048

Using SST, remove the oil seal.

SST
09308-10010  


b.

Remove the oil slinger.


Hide 3.REMOVE FRONT BEARING AND BEARING SPACER

a.
C397049

Using SST, remove the front bearing from the drive pinion.

SST
09556-22010  


b.

Remove the 2 shims and a bearing spacer.


Hide 41301 4.REMOVE DIFFERENTIAL CASE

a.
C397050

Place matchmarks on the bearing cap and differential carrier.


b.

Remove the 2 adjusting nut locks.


c.

Remove the 4 bolts and the 2 bearing caps.


d.

Remove the 2 adjusting nuts.


e.
C397051

Remove the differential case with the side bearing outer races from the differential carrier.

HINT:
C397052

Tag the disassembled parts to show the location for reassembly.



Hide 5.REMOVE DRIVE PINION

Remove the drive pinion with the rear bearing.

Hide 41201A 6.REMOVE DRIVE PINION REAR BEARING

C397053

Using SST and a press, remove the bearing from the drive pinion.

SST
09950-00020  

HINT:

If the drive pinion or ring gear are damaged replace them as a set.


Hide 7.REMOVE FRONT AND REAR BEARING OUTER RACES

C397054

Using a hammer and brass bar, drive out the outer races from the carrier.

Hide 8.REMOVE RING GEAR

a.
C397055

Place matchmarks on the ring and differential case.


b.

Using a screwdriver, unstake the lock plates.


c.

Remove the 12 bolts and 6 lock plates.


d.
C397056

Using a plastic-faced hammer, tap on the ring gear to separate it from the differential case.


Hide 41301A 9.REMOVE SIDE BEARINGS

a.
C397057

Using SST, remove the side bearing from the differential case.

SST
09950-40011  


Hide 10. DISASSEMBLE DIFFERENTIAL CASE

a.
C397058

Place the matchmarks on the LH and RH cases.


b.

Protect the ring gear with a cloth and secure it in a vise and remove the 12 bolts.


c.
C397059

Using a plastic-faced hammer, separate the LH and RH cases.


d.
C397060

Remove the following parts:

·

Spider

·

Pinion gears

·

Pinion gear thrust washers

·

Side gears

·

Side gear thrust washers