Home › Drivetrain › M15# (MANUAL TRANSMISSION / TRANSAXLE) › INPUT SHAFT
RM2850E _52 Drivetrain _073186 M15# MANUAL TRANSMISSION / TRANSAXLE _0356139 INPUT SHAFT G

M15# MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  INSPECTION  


PROCEDURE

Hide 33367 1.INSPECT SYNCHRONIZER RING

C395840

a.

Check for wear or damage.


b.

Check the braking effect of the synchronizer ring.

Turn the synchronizer ring in one direction while pushing it to the gear cone. Check that the ring locks. If the braking effect is insufficient, apply a small amount of fine lapping compound between the synchronizer ring and gear cone.

Lightly rub the synchronizer ring and gear cone together.

NOTICE:

Wash off completely the fine lapping compound after rubbing.



c.

Check again the braking effect of the synchronizer ring. If it does not lock replace synchronizer ring.


d.
C395841

Using a feeler gauge, measure the clearance between the synchronizer ring back and gear spline end.

Minimum clearance:

0.8 mm (0.031 in.)


HINT:
·

When replacing either a synchronizer ring or gear, apply a small amount of fine lapping compound between the synchronizer ring and gear cone.

Lightly rub the synchronizer ring and gear cone together.

·

When replacing both the synchronizer ring and gear, there is no need to apply any compound or to rub them together.



NOTICE:

Wash off completely the fine lapping compound after rubbing.