33263C
1.INSTALL NO. 2 SHIFT LEVER AND SHAFT
Install the No. 2 shift lever and shaft.
Apply MP grease to the straight pin.
Align the pin hole of the shaft and housing, and install the straight pin.
Install the 2 E-rings.
Apply seal packing to the tight plug.
Part No. 08833-00070, THREE BOND 1324 or equivalent
Install the tight plug to the housing.
1.7 to 2.5 mm (0.067 to 0.098 in.)
33262E
2.INSTALL SHIFT AND SELECT LEVER AND SHAFT
Install the shift and select lever, 2 compression springs and seat.
Install the shift lever shaft.
Using a pin punch and hammer, drive in the slotted spring pin.
33531B
3.INSTALL SELECT OUTER LEVER AND BOOT
Install the shift outer lever and boot to the housing.
Using a brass bar and hammer, drive in the lever lock pin.
Install the washer and nut. Torque the nut.
20 N*m (200 kgf*cm, 15 ft.*lbf)
33257
4.INSTALL SELECT OUTER LEVER AND LEVER SHAFT
Install the select lever shaft.
Align the tip of select lever shaft and shift and select lever slots.
Install the plate washer and select outer lever.
Using a pin punch and hammer, drive in the lever lock pin.
Install the washer and nut. Torque the nut.
7.8 N*m (80 kgf*cm, 69 in.*lbf)