Home › Drivetrain › M551 (MANUAL TRANSMISSION / TRANSAXLE) › INPUT SHAFT
RM2850E _52 Drivetrain _073187 M551 MANUAL TRANSMISSION / TRANSAXLE _0356152 INPUT SHAFT A

M551 MANUAL TRANSMISSION / TRANSAXLE  INPUT SHAFT  DISASSEMBLY  


PROCEDURE

Hide 1.INSPECT 5TH GEAR THRUST CLEARANCE

a.
C146851

Using a feeler gauge, measure the 5th gear thrust clearance.

Standard clearance:

0.10 to 0.35 mm (0.0039 to 0.0138 in.)


Maximum clearance:

0.35 mm (0.0138 in.)



Hide 2.INSPECT 5TH GEAR RADIAL CLEARANCE

a.
C146852

Fix the input shaft through 2 protective aluminum plates in a vise.


b.

Using a dial indicator, measure the 5th gear radial clearance.

Standard clearance:

0.015 to 0.068 mm (0.0006 to 0.0027 in.)


Maximum clearance:

0.068 mm (0.0027 in.)


If the clearance exceeds the maximum, replace the gear, needle roller bearing or shaft.


c.

Remove the input shaft from the vise.


Hide 33393A 3.REMOVE TRANSMISSION CLUTCH HUB NO. 3 SHAFT SNAP RING

a.
C146853

Using 2 screwdrivers and a hammer, tap out the snap ring.

NOTICE:

Use a shop rag or piece of cloth to prevent the snap ring from flying off.



Hide 4.REMOVE 5TH GEAR

a.
C146854E02
1.813,1.115 2.333,0.802 2.333,0.802 1.781,0.802 true 2.396,0.74 2.854,0.938 0.458,0.198 10 false SST

Using SST and a press, press out the 5th gear, No. 3 clutch hub, needle roller bearing and synchronizer ring.

SST
09950-70010  (09951-07100)
09950-60011  (09951-00350)


Hide 33393 5.REMOVE NO. 3 TRANSMISSION CLUTCH HUB

a.
C146855

Using a screwdriver, remove the 2 key springs, 3 keys and hub sleeve from the No. 3 clutch hub.


Hide 33346B 6.REMOVE 5TH GEAR THRUST WASHER

a.
C146863E02
2.417,1.24 2.792,0.792 true 2.823,0.708 3.188,0.906 0.365,0.198 10 false SST

Using SST and a press, press out the thrust washer.

SST
09950-00020  


Hide 33342A 7.REMOVE GEAR THRUST WASHER STRAIGHT PIN

a.
C146864

Remove the pin from the input shaft.


Hide 33311G 8.REMOVE FRONT BEARING SHAFT SNAP RING

a.
C146865

Using 2 screwdrivers and a hammer, tap out the snap ring.

NOTICE:

Use a shop rag or piece of cloth to prevent the snap ring from flying off.



Hide 33311A 9.REMOVE INPUT SHAFT FRONT BEARING

a.
C146866E02
2.156,1.469 2.542,1.01 true 2.615,0.906 3.031,1.094 0.417,0.188 10 false SST

Using SST and a press, press out the bearing.

SST
09950-00020