Home › Drivetrain › M551 (MANUAL TRANSMISSION / TRANSAXLE) › OUTPUT SHAFT
RM2850E _52 Drivetrain _073187 M551 MANUAL TRANSMISSION / TRANSAXLE _0356153 OUTPUT SHAFT G

M551 MANUAL TRANSMISSION / TRANSAXLE  OUTPUT SHAFT  INSPECTION  


PROCEDURE

Hide 33321 1.INSPECT OUTPUT SHAFT

a.
C146889

Using a cylinder gauge, measure the inside diameter of the output shaft bearing race.

Standard inside diameter:

54.17 to 54.187 mm (2.1327 to 2.1333 in.)


Maximum inside diameter:

54.187 mm (2.1333 in.)


If the diameter exceeds the maximum, replace the output shaft.


Hide 2.INSPECT NO. 4 SYNCHRONIZER RING

a.
C146890

Using a feeler gauge, measure the clearance between the synchronizer ring and gear spline.

Standard clearance:

0.78 to 1.62 mm (0.0307 to 0.0638 in.)


Minimum clearance:

0.78 mm (0.0307 in.)


If the clearance is less than the minimum, replace the synchronizer ring.


b.
C146891

Coat the output shaft and synchronizer ring cone with gear oil. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the gear cone. Check that the ring locks.

If the braking effect is insufficient, apply a small amount of the fine lapping compound between the synchronizer ring and 4th gear cone. Lightly rub the synchronizer ring and 4th gear cone together.

NOTICE:

Ensure the fine lapping compound is completely washed off after rubbing.



c.

Check again the braking effect of the synchronizer ring.