69350
1.INSPECT BACK DOOR LOCK ASSEMBLY (w/ Courtesy Switch)
Check the back door lock assembly operation.
Apply battery voltage to the back door lock assembly terminals.
| Battery Connection | Specified Condition |
|---|---|
| Battery positive (+) → 4 (L)
Battery negative (-) → 2 (UL) |
LOCK |
| Battery positive (+) → 2(UL)
Battery negative (-) → 4 (L) |
UNLOCK |
| *a | Lock |
| *b | Unlock |
| *c | Component without harness connected
(Back Door Lock Assembly) |
If the result is not as specified, replace the back door lock assembly.
Check the position switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 3 | LOCK | 10 kΩ or higher |
| UNLOCK | Below 1 Ω |
If the result is not as specified, replace the back door lock assembly.
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Close | *b | Open |
| *c | Component without harness connected
(Back Door Lock Assembly) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Close | 10 kΩ or higher |
| Open | Below 1 Ω |
If the result is not as specified, replace the back door lock assembly.
69350
2.REMOVE BACK DOOR LOCK ASSEMBLY (w/o Courtesy Switch)
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Close | *b | Open |
| *c | Component without harness connected
(Back Door Lock Assembly) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Close | 10 kΩ or higher |
| Open | Below 1 Ω |
If the result is not as specified, replace the back door lock assembly.