Home › Vehicle Interior › DOOR LOCK › CENTER DOOR LOCK (for Glide Type)
RM2850E _58 Vehicle Interior _073188 DOOR LOCK _0356164 CENTER DOOR LOCK(for Glide Type) G

DOOR LOCK  CENTER DOOR LOCK(for Glide Type)  INSPECTION  


PROCEDURE

Hide 85450A 1.INSPECT DOOR CONTROL MOTOR ASSEMBLY

a.
B239760E02
1.135,4.146 1.417,3.698 true 1.979,4.156 1.75,3.708 true 0.219,0.24 0.531,0.438 0.313,0.198 10 false *1 0.99,4.167 1.417,4.396 0.427,0.229 10 false UL 2.021,4.167 2.448,4.396 0.427,0.229 10 false L 2.844,0.26 3.354,0.5 0.51,0.24 10 false Unlock 2.854,0.969 3.365,1.208 0.51,0.24 10 false Lock

Check the operation of the door lock motor.

Text in Illustration
*1 Component without harness connected
(Door control motor assembly)

i.

Apply battery voltage to the motor terminals.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 2 (L)
Battery negative (-) → 3 (UL)
Locks
Battery positive (+) → 3 (UL)
Battery negative (-) → 2 (L)
Unlocks


If the result is not as specified, replace the door control motor.



Hide 69330B 2.INSPECT GLIDE DOOR FRONT LOCK ASSEMBLY

a.

Check the resistance.

B511350E01
0.135,0.125 0.448,0.323 0.313,0.198 10 false *1 1.156,0.115 1.677,0.333 0.521,0.219 10 false Lock 4.125,0.094 4.771,0.365 0.646,0.271 10 false Unlock

Text in Illustration
*1 Component without harness connected
(Glide door front lock assembly)

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Locked 10 kΩ or higher
1 - 2 Unlocked Below 1 Ω


If the result is not specified, replace the glide door front lock.



Hide 69340A 3.INSPECT GLIDE DOOR REAR LOCK ASSEMBLY

a.
B239761E02
0.198,0.156 0.51,0.354 0.313,0.198 10 false *1 0.5,1.552 1.469,1.813 0.969,0.26 10 false Not depresed 0.521,2.927 1.49,3.188 0.969,0.26 10 false Depresed

Check the resistance of the rear door courtesy switch.

Text in Illustration
*1 Component without harness connected
(Glide door rear lock assembly)

i.

Measure the resistance according to thevalue(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - Body Shaft depressed 10 kΩ or higher
1 - Body Shaft not depressed Below 1 Ω


If the result is not specified, replace the glide door rear lock.