Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
1.DISCONNECT CENTER DOOR REMOTE CONTROL ROD ASSEMBLY (for Manual Type Center Door)
71750A
2.REMOVE FRONT SEAT UNDER TRAY ASSEMBLY
Pull up the front seat under tray assembly to release the lock to remove it.
3.REMOVE FRONT SEAT ASSEMBLY RH
Operate the seat track adjusting handle to slide the front seat assembly RH to the front most position.
Remove the rear side of the 2 bolts.
Operate the seat track adjusting handle to slide the front seat assembly RH to the rearmost position.
Remove the front side of the 2 bolts.
w/ seat belt warning system:
Detach the 2 wire harness clamps and disconnect the connector.
Remove the front seat assembly RH from the vehicle.
Protect the front seat legs.
Do not damage the front seat assembly RH, body exterior or interior parts.
71108B
4.REMOVE FRONT SEAT LEG SUB-ASSEMBLY RH
Remove the 4 bolts and front seat leg sub-assembly RH.