Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY
RM2850E _58 Vehicle Interior _073189 SEAT _0356165 FRONT SEAT ASSEMBLY A

SEAT  FRONT SEAT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for RHD vehicles.



PROCEDURE

Hide 71108B 1.INSTALL FRONT SEAT LEG SUB-ASSEMBLY RH

a.
B466253

Install the front seat leg sub-assembly RH with the 4 bolts.

Torque:

37 N*m (377 kgf*cm, 27 ft.*lbf)



Hide 2.INSTALL FRONT SEAT ASSEMBLY RH

a.

Place the front seat assembly RH in the cabin.

NOTICE:
·

Protect the front seat legs.

·

Do not damage the front seat assembly RH, body exterior or interior parts.




b.
B466254

w/ Seat Belt Warning System:

Pass the wire harness of the front seat inner belt assembly RH through the position on the front seat leg sub-assembly RH indicated in the illustration.


c.

Temporarily install the front seat assembly RH with the 4 bolts.


d.

Operate the seat track adjusting handle to slide the front seat assembly RH to the rearmost position.


e.
B290217

w/ Seat Belt Warning System:

Connect the connector and attach the 2 wire harness clamps.


f.
B466251

Tighten the front side of the 2 bolts.

Torque:

37 N*m (377 kgf*cm, 27 ft.*lbf)



g.

Operate the seat track adjusting handle to slide the front seat assembly RH to the front most position.


h.
B466252

Tighten the rear side of the 2 bolts.

Torque:

37 N*m (377 kgf*cm, 27 ft.*lbf)



Hide 71750A 3.INSTALL FRONT SEAT UNDER TRAY ASSEMBLY

a.
B466250

Install the front seat under tray assembly.


Hide 4.CONNECT CENTER DOOR REMOTE CONTROL ROD ASSEMBLY (for Manual Type Center Door)

Hide 5.INSPECT SEAT BELT WARNING SYSTEM (w/ Seat Belt Warning System)

a.

Turn the ignition switch on (IG).


b.

Check that the driver side seat belt warning light blinks on the combination meter assembly when the seat belt tongue plate is not inserted to the buckle.


c.

Check that the driver side seat belt warning light turns off on the combination meter assembly when the seat belt tongue plate is inserted to the buckle.