Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
1.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
2.REMOVE REAR NO. 1 SEAT ASSEMBLY LH
79097
3.REMOVE LUGGAGE COMPARTMENT WALL PARTITION SUB-ASSEMBLY
Remove the 5 screws and 3 bolts.
|
Screw |
|
Bolt |
|
Fastener |
Detach the 9 fasteners to remove the luggage compartment wall partition sub-assembly.
79805A
4.REMOVE FRONT FOLD SEAT LEG SUB-ASSEMBLY
Remove the 2 bolts and front fold seat leg sub-assembly.
5.REMOVE NO. 8 SEAT ASSEMBLY
Pull the seat lock band assembly and fold the No. 8 seat assembly.
Loosen the 2 bolts and disconnect the 2 No. 1 fold seat stopper band assemblies.
Remove the 4 nuts.
2 or more persons are required for the following procedure in order to prevent damage of the vehicle interior.
| *A | LH Side | *B | RH Side |
|
Nut |
|
Bolt |
Lift up and remove the rear No. 8 seat assembly from the vehicle.
79916
6.REMOVE NO. 2 SEAT LEG BRACKET
Remove the 2 nuts and No. 2 seat leg bracket.
79915
7.REMOVE SEAT LEG BRACKET
Use the same procedure described for the No. 2 seat leg bracket.
78904
8.REMOVE NO. 2 FOLD SEAT LOCK STRIKER SUB-ASSEMBLY
Remove the 3 nuts and No. 2 fold seat lock striker sub-assembly.
78903
9.REMOVE FOLD SEAT LEG LOCK STRIKER SUB-ASSEMBLY
Use the same procedure described for the No. 2 fold seat lock striker sub-assembly.