Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
73230
1.INSPECT FRONT SEAT INNER BELT ASSEMBLY RH
Measure the resistance according to the value(s) in the table below.
| *a | Component without harness connected
(Front Seat Inner Belt Assembly RH) |
|
Fastened |
|
Unfastened |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1(+) - 2(E) | Seat belt unfastened | Below 1 Ω |
| 1(+) - 2(E) | Seat belt fastened | 10 kΩ or higher |
If the result is not as specified, replace the front seat inner belt assembly RH.