Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
73220
1.INSPECT FRONT SEAT OUTER BELT ASSEMBLY LH (for 1st Row Seat)
Do not disassemble the retractor.
Before installing the front seat outer belt assembly LH, check the ELR.
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
| *a | Unlocked |
| *b | Locked |
| *c | 45° |
If the operation is not as specified, replace the front seat outer belt assembly LH.
73220
2.INSPECT FRONT SEAT OUTER BELT ASSEMBLY LH (except 2nd Row Seat)
Do not disassemble the retractor.
Before installing the rear seat outer belt assembly, check the ELR.
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
| *a | Unlocked |
| *b | Locked |
| *c | 45° |
If the operation is not as specified, replace the rear seat outer belt assembly.
73302
3.INSPECT REAR SEAT OUTER BELT SUB-ASSEMBLY (for 2nd Row Seat)
Do not disassemble the retractor.
Before installing the rear seat outer belt assembly, check the ELR.
When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
| *a | Unlocked |
| *b | Locked |
| *c | 45° |
If the operation is not as specified, replace the rear seat outer belt sub-assembly.