Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
62375B
1.REMOVE NO. 1 SIDE WINDOW CLIP
When reusing the front side window glass LH:
Do not damage the front side window glass LH.
Be sure to replace the front side window glass LH with a new one.
Using a scraper, remove the 3 No. 1 side window clips.
| *a | Back Side |
62763N
2.REMOVE SIDE WINDOW FRAME RETAINER
When reusing the front side window glass LH:
Do not damage the front side window glass LH.
Be sure to replace the side window frame retainer with a new one.
Using a scraper, remove the 3 side window frame retainers.
| *a | Back Side |
62391B
3.REMOVE NO. 1 FRONT SIDE WINDOW STOPPER LH
Be sure to replace the removed No. 1 front side window stopper LH with a new one.
Remove the 2 screws and No. 1 front side window stopper LH.
62121
4.REMOVE FRONT SIDE FRONT WINDOW GLASS LH
When reusing the front side window glass LH:
Do not damage the front side window glass LH.
Do not damage the window frame.
Do not damage the front side front window glass LH.
Move the front side front window glass LH and rear side window glass LH to the center.
Remove the 2 screws.
Remove any old sealant sticking to the head of the screw before removing it.
Widen top and bottom of the window frame using your hands and remove the front side front window glass LH.
62211F
5.REMOVE REAR SIDE WINDOW GLASS LH
When reusing the front side window glass LH:
Do not damage the front side window glass LH.
Do not damage the window frame.
Do not damage the rear side window glass LH.
Remove the 2 screws and center side window frame sub-assembly.
Widen top and bottom of the window frame using your hands and remove the rear side window glass LH.
62777U
6.REMOVE SIDE WINDOW CENTER SASH CAP
Perform the following procedures when replacing the side window center sash cap.
Be sure to replace the removed side window center sash cap with a new one.
Remove the side window center sash cap.
62746G
7.REMOVE QUARTER WINDOW PACKING
Perform the following procedures when replacing the quarter window packing.
Be sure to replace the removed quarter window packing with a new one.
Make sure that the side window center frame sub-assembly LH is not deformed when removing the quarter window packing.
The quarter window packing is installed with adhesive.
Remove the EPT sealer shown in the illustration.
Replace the removed EPT sealer with a new one.
A generic EPT sealer can be used.
Remove the quarter window packing from the side window center frame sub-assembly LH.
62910L
8.REMOVE SIDE WINDOW LOCK ASSEMBLY
Use the same procedure for each of the side window lock assemblies.
Remove the 2 screws and side window lock assembly.
Remove the side window lock retainer.
Remove the side window lock packing.
68142D
9.REMOVE SIDE FRONT WINDOW RUN LH
Perform the following procedures when replacing the side front window run LH.
Be sure to replace the removed side front window run LH with a new one.
The side front window run LH is installed with adhesive.
Remove the side front window run LH.
| *a | Back Side |
62269F
10.REMOVE SIDE WINDOW FRAME FILM
Perform the following procedures when replacing the side window frame film.
Be sure to replace the removed side window frame film with a new one.
Remove the 9 pieces of side window frame film.
| *a | Back Side | - | - |
|
Tape | - | - |