Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
69277B
1.REMOVE FRONT DOOR INSIDE HANDLE BEZEL RH
81230
2.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
67601
3.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH
74811B
4.REMOVE DOOR PULL HANDLE
62778A
5.REMOVE FRONT SIDE WINDOW SASH CAP
Remove the front side window sash cap.
6.REMOVE FRONT DOOR WINDOW ASSEMBLY RH
Install the suction cups to the front door window assembly RH.
Remove the No. 1 side window clip.
From the interior, insert a knife between the vehicle door panel and glass.
Cut through the adhesive by knife around the butyl tape.
Start this procedure where the front door window assembly RH and door panel are furthest apart.
Using suction cups, remove the front door window assembly RH.
Be careful not to drop the front door window assembly RH.