Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
62385A
1.REMOVE NO. 1 FRONT DOOR WINDOW SEAL
Perform the following procedures when replacing the No. 1 front door window seal.
Be sure to replace the removed No. 1 front door window seal with a new one.
The No. 1 front door window seal is installed with adhesive.
Remove the No. 1 front door window seal.
| *a | Back side |
62385C
2.REMOVE NO. 1 SIDE WINDOW SEAL
Perform the following procedures when replacing the No. 1 side window seal.
Be sure to replace the removed No. 1 side window seal with a new one.
The No. 1 side window seal is installed with adhesive.
Remove the No. 1 side window seal.
| *a | Back side |
67120D
3.REMOVE FRONT DOOR WINDOW STOPPER
Be sure to replace the removed front door window stopper with a new one.
Remove the 2 screws and front door window stopper.
62315D
4.REMOVE FRONT DOOR FRONT WINDOW GLASS RH
Do not damage the front door window glass assembly RH.
Do not damage the front door out window frame sub-assembly.
Do not damage the front door front window glass RH.
Move the front door front window glass RH and front door rear window glass RH to the center.
Remove the 2 screws.
Remove any old sealant sticking to the head of the screw before removing it.
Widen top and bottom of the window frame using your hands and remove the front door front window glass RH.
62039
5.REMOVE FRONT DOOR CENTER WINDOW FRAME SUB-ASSEMBLY RH
Do not damage the front door center window frame sub-assembly RH.
Do not damage the front door out window frame sub-assembly.
Remove the 2 screws and front door center window frame sub-assembly RH.
62317
6.REMOVE FRONT DOOR REAR WINDOW GLASS RH
Do not damage the front door window glass assembly RH.
Do not damage the front door out window frame sub-assembly.
Do not damage the front door rear window glass RH.
Widen top and bottom of the window frame using your hands and remove the front door rear window glass RH.
62777U
7.REMOVE FRONT DOOR WINDOW CENTER SASH CAP RH
Perform the following procedures when replacing the front door window center sash cap RH.
Be sure to replace the front door window center sash cap RH with a new one.
Remove the front door window center sash cap RH.
62746G
8.REMOVE QUARTER WINDOW PACKING
Perform the following procedures when replacing the quarter window packing.
Be sure to replace the removed quarter window packing with a new one.
Make sure that the front door window center frame sub-assembly RH is not deformed when removing the quarter window packing.
The quarter window packing is installed with adhesive.
Remove the EPT sealer shown in the illustration.
Replace the removed EPT sealer with a new one.
A generic EPT sealer can be used.
Remove the quarter window packing from the front door window center frame sub-assembly RH.
62910L
9.REMOVE SIDE WINDOW LOCK ASSEMBLY
Use the same procedure for each of the side window lock assemblies.
Remove the 2 screws and side window lock assembly.
Remove the side window lock retainer.
Remove the side window lock packing.
62411K
10.REMOVE FRONT DOOR WINDOW RUN RH
Perform the following procedures when replacing the front door window run RH.
Be sure to replace the removed front door window run RH with a new one.
The front door window run RH is installed with adhesive.
Remove the front door window run RH.
62269E
11.REMOVE FRONT WINDOW FRAME FILM RH
Perform the following procedures when replacing the front window frame film RH.
Be sure to replace the removed front window frame film RH with a new one.
Remove the 5 pieces of front window frame film RH.
| *a | Back side |
|
Tape |
12.REMOVE FRONT WINDOW PACKING
Perform the following procedures when replacing the front door window packing.
Be sure to replace the front door window packing with a new one.
Remove the 2 front door window packings.
| *1 | Front Door Window Packing | - | - |
| *a | Back side | *b | Hole |