69298F
1.REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH
69278
2.REMOVE NO. 1 DOOR INSIDE HANDLE BEZEL LH
68218D
3.REMOVE CENTER DOOR FIX WINDOW BUSH
74642
4.REMOVE FOLDING DOOR ASSIST GRIP
68111
5.REMOVE CENTER DOOR GLASS
The center door glass may fall while performing this procedure. Therefore, use suction cups to hold the center door glass from the outside of the vehicle.
Apply protective tape to the interior and exterior door panels around the center door glass.
| *A | Inside of the Vehicle | *B | Outside of the Vehicle |
| *1 | Protective Tape | - | - |
Install the suction cups to the center door glass.
From the interior, insert a piano wire between the door panel and glass.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
When separating the glass from the door panel, Do not damage the vehicle paint or interior/exterior ornaments.
| *1 | No. 1 Side Window Pin |
| *2 | Piano Wire |
Cut through the adhesive by pulling the piano wire around the glass.
Using suction cups, disconnect the 3 No. 1 side window pins and remove the center door glass.
Be careful not to drop the center door glass.
62267V
6.REMOVE SIDE WINDOW ADHESIVE DAM
When reusing the center door glass:
Using a scraper, remove the 4 side window adhesive dams.
Do not damage the center door glass.
Be sure to replace the side window adhesive dam with a new one.
Use the same procedure for each of the center door glass.
| *a | Back Side |
68217A
7.REMOVE NO. 1 SIDE WINDOW PIN
When reusing the center door glass:
Using a scraper, remove the 6 No. 1 side window pins.
Do not damage the center door glass.
Be sure to replace the No. 1 side window pin with a new one.
| *A | Rear Side |
| *B | Front Side |
| *a | Backside |