44310
1.FIX VANE PUMP ASSEMBLY
Using SST, fix the vane pump assembly in a vise.
44337
2.REMOVE POWER STEERING SUCTION PORT UNION
Remove the bolt and power steering suction port union.
Remove the O-ring from the power steering suction port union.
44330
3.REMOVE FLOW CONTROL VALVE
Using a socket wrench (27mm), remove the pressure port union from the vane pump front housing.
Remove the O-ring from the pressure port union.
Remove the flow control valve and spring.
44304
4.REMOVE VANE PUMP REAR HOUSING
Remove the 4 bolts and the vane pump rear housing from the vane pump front housing.
If the vane pump rear housing cannot be removed easily, tap the vane pump rear housing with a plastic-faced hammer.
Remove the O-ring from the vane pump rear housing.
5.REMOVE VANE PUMP ROTOR
Remove the 10 vane pump plates.
Be careful not to drop the vane pump plates.
Remove the vane pump rotor.
Be careful not to drop the vane pump rotor.
6.REMOVE VANE PUMP CAM RING
Remove the vane pump cam ring.
7.REMOVE VANE PUMP FRONT SIDE PLATE
Remove the vane pump front side plate from the vane pump front housing.
Remove the O-ring from the vane pump front side plate.
Remove the O-ring from the vane pump front housing.
44316
8.REMOVE VANE PUMP GEAR
Using a screwdriver with its tip wrapped in protective tape, remove the snap ring from the vane pump front housing.
| *1 | Protective Tape |
Apply protective tape to the serrated part of the vane pump shaft.
Using a press, remove the vane pump gear together with the vane pump shaft with vane pump shaft bearing.
| *1 | Protective Tape |
| *2 | Press |
Do not drop the vane pump gear.
Install the service bolt onto the vane pump shaft.
| Part No | 91111-51050 |
| Thread diameter | 10 mm (0.3937 in.) |
| Thread pitch | 1.25mm (0.0492 in.) |
Using SST and a press, remove the vane pump gear from the vane pump shaft.
| *1 | Press |
| *2 | Service Bolt |
44312A
9.REMOVE VANE PUMP SHAFT BEARING
Using SST and a press, remove the vane pump shaft bearing from the vane pump shaft.
| *1 | Press |
| *2 | Service Bolt |
Using a snap ring expander, remove the snap ring from the vane pump shaft.
44302G
10.REMOVE VANE PUMP HOUSING OIL SEAL
Using SST, remove the vane pump housing oil seal from the vane pump front housing.
| *1 | Hold |
| *2 | Turn |