Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 14B) › 2017.01–2019.08
RM2850E _55 Steering _073197 POWER ASSIST SYSTEMS _0356231 VANE PUMP(for 14B) A

POWER ASSIST SYSTEMS  VANE PUMP(for 14B)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE DRIVE GEAR

a.
C397845

Using snap ring pliers, remove the snap ring from the shaft.


b.

Remove the gear and woodruff key.


Hide 2.REMOVE REAR HOUSING

a.
C397846

Place matchmarks on the front and rear housings.


b.

Remove the 4 bolts.


c.

Using a plastic hammer, tap off the front housing.

NOTICE:

Be careful that the vane plates, rotor and cam ring do not fall out.



d.

Remove the O-ring.


Hide 3.REMOVE CAM RING, ROTOR, VANE PLATES AND STRAIGHT PIN

NOTICE:
C397847

Be careful not to scratch the cam ring, rotor, and vane plates.


Hide 4.REMOVE ROTOR SHAFT

a.
C397848

Using snap ring pliers, remove the snap ring.


b.
C397849

Using a press out the rotor shaft with the bearing.


Hide 5.REMOVE PRESSURE PLATE AND SPRING

a.
C397850

Using a plastic hammer, tap the bottom end of the rear housing, and remove the pressure plate and spring.

NOTICE:

Be careful not to scratch the front side of the pressure plate.



b.

Remove the O-ring.


Hide 6.REMOVE VALVE LOCK SCREW

a.
C397851

Remove the valve lock screw.


b.

Remove the O-ring.


Hide 7.REMOVE COMPRESSION SPRING AND FLOW CONTROL VALVE