Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 14B) › 2017.01–2019.08
RM2850E _55 Steering _073197 POWER ASSIST SYSTEMS _0356231 VANE PUMP(for 14B) G

POWER ASSIST SYSTEMS  VANE PUMP(for 14B)  INSPECTION  


PROCEDURE

Hide 1.INSPECT ROTOR, CAM RING AND VANE PLATES

a.
C397852

Check the cam ring and rotor for wear or scratches, if necessary, replace the cam ring, the rotor and the vane plates as a set.


Hide 44330 2.INSPECT FLOW CONTROL VALVE

a.
C397853

Check the flow control valve for wear or damage.


b.

Apply fluid to the valve and check that it falls smoothly into the valve hole by its own weight.


c.

Check the flow control valve for leakage.

Close one of the holes and apply compressed air [392 or 490 kPa (4 or 5 kg/cm2, 57 or 71 psi)] into the opposite side, and confirm that air does not come out from the end hole.


d.
C397854

If necessary, replace the valve with one having the letter as inscribed on the rear housing.

Pump housing number Valve cutter mark
0 II
1 I
2 None


Hide 44330A 3.INSPECT FLOW CONTROL VALVE SPRING

a.
C397855

Check that the spring length is within specification.

Spring length:

50 - 55 mm (1.97 - 2.17 in.)


If the spring is not within specification, replace it.


Hide 4. IF NECESSARY, REPLACE ROTOR SHAFT BEARING

a.
C397856

Using 2 screwdrivers, remove the snap ring.


b.
C397857

Using a press, press out the bearing.


c.

Using a press, press in a new bearing.

NOTICE:

Be careful not to scratch the rotor shaft contact surface with oil seal and bearing.



d.
C397858

Install the snap ring.


Hide 5. IF NECESSARY, REPLACE OIL SEAL

a.
C397859

Clamp the front housing in a vise.

NOTICE:

Do not tighten the vise too tight.



b.

Using a screwdriver, remove the oil seal.

NOTICE:

Be careful not scratch the housing with a screwdriver.



c.
C397860

Apply MP grease to the lip and outside of a new oil seal.


d.

Using SST and a press, press in the oil seal to the front housing.

SST
09630-24014  (09620-24021)

NOTICE:

Be careful not to scratch the frictional surface of the front housing.