Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 14B) › 2017.01–2019.08
RM2850E _55 Steering _073197 POWER ASSIST SYSTEMS _0356231 VANE PUMP(for 14B) A

POWER ASSIST SYSTEMS  VANE PUMP(for 14B)  REASSEMBLY  


PROCEDURE

Hide 1. COAT POWER STEERING FLUID ON EACH PARTS

Hide 2.INSTALL FOLLOW CONTROL VALVE AND SPRING

a.
C397861

Insert the spring and valve to the rear housing.


Hide 3.INSTALL VALVE LOCK SCREW

a.

Install a new O-ring to the valve lock screw.


b.

Install the valve lock screw.

Torque:

64 N*m (650 kgf*cm, 47 ft.*lbf)



Hide 4.INSTALL ROTOR SHAFT

a.
C397862

Using SST and a press, press in the rotor shaft to the front bushing.

SST
09632-36010  

NOTICE:

Be careful not to scratch the oil seal lip and the rotor frictional surface.



b.
C397863

Using snap ring pliers, install the snap ring.


Hide 5.INSTALL O-RING AND STRAIGHT PIN

a.

Install a new O-ring and straight pin to the front housing.


Hide 6.INSTALL CAM RING

a.
C397864

Install the cam ring with the inscribed mark facing upper side.


Hide 7.INSTALL ROTOR

a.
C397865

Install the rotor, as shown.


Hide 8.INSTALL VANE PLATES

a.
C397866

Install the 10 vane plates with the round end facing outward.


Hide 9.INSTALL PRESSURE PLATE AND SPRING

a.
C397867

Align the cut portion of the pressure plate to the straight pin and install it.


b.

Place the spring on the pressure plate.


Hide 10.INSTALL REAR HOUSING

a.
C397868

Apply fluid to a new O-ring and install it to the rear housing.


b.

Align the matchmarks on the front and rear housings and assemble them.


c.
C397869

Torque the 4 bolts.

Torque:

37 N*m (375 kgf*cm, 27 ft.*lbf)



Hide 11.INSTALL VANE PUMP GEAR

a.
C397870

Install the vane pump gear, as shown.


b.

Using snap ring pliers, install the snap ring.


Hide 12.CHECK ROTOR SHAFT ROTATION CONDITION

a.

Check that the rotor shaft rotates smoothly without abnormal noise.