Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 1HZ)
RM2850E _55 Steering _073197 POWER ASSIST SYSTEMS _0356232 VANE PUMP(for 1HZ) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1HZ)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE DRIVE GEAR

a.
C397872

Using soft jaws on a vise clamp the gear in the vise.


b.

Remove the gear lock nut.


c.
C397873

Using SST and a press, remove the gear from the drive shaft.

SST
09527-10011  


d.

Remove the woodruff key.


Hide 2.REMOVE VALVE LOCK SCREW, SPRING AND FLOW CONTROL VALVE

a.
C397874

Remove the valve lock screw, spring and control valve.


b.

Remove the O-ring from the valve lock screw.


Hide 3.REMOVE FRONT HOUSING

a.
C397875

Place matchmarks on the front and rear housings.


b.

Remove the 3 bolts and the front housing,


c.

Remove the O-ring front the housing.


Hide 4.REMOVE ROTOR AND VANE PLATES

NOTICE:
C397876

Be careful that the vane plates and rotor do not fall out.


Hide 5.REMOVE STRAIGHT PIN

Hide 6.REMOVE O-RING

Hide 7.REMOVE ROTOR SHAFT

a.
C397877

Using snap ring pliers, remove the snap ring.


b.
C397878

Using a press, press out the rotor shaft with the bearing.


Hide 8.REMOVE CAM RING, PRESSURE PLATE AND SPRING

a.
C397879

Using a plastic hammer, tap the bottom end of the rear housing, and remove the pressure plate and spring.

NOTICE:

Be careful not to scratch the front side of the pressure plate.



b.

Remove the O-ring front the rear housing.