Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 1HZ)
RM2850E _55 Steering _073197 POWER ASSIST SYSTEMS _0356232 VANE PUMP(for 1HZ) G

POWER ASSIST SYSTEMS  VANE PUMP(for 1HZ)  INSPECTION  


PROCEDURE

Hide 1.INSPECT ROTOR, CAM RING AND VANE PLATES

a.
C397880

Check the cam ring for wear or scratches. If necessary, replace the cam ring, the rotor and the vane plates in a set.


Hide 44330 2.INSPECT FLOW CONTROL VALVE

a.
C397881

Check the flow control valve for wear or damage.


b.

Apply fluid to the valve and check that it falls smoothly into the valve hole by its own weight.


c.
C397882

Check the flow control valve for leakage, close one of the holes and apply compressed air [392 or 490 kPa (4 or 5 kg/cm2, 57 or 71 psi)] into the opposite side, and confirm that air does not come out from the end hole.


d.
C397883

If necessary, replace the valve with one having the letter as inscribed on the rear housing.

Pump housing number Valve cutter mark
0 II
1 I
2 None


Hide 44330A 3.INSPECT FLOW CONTROL VALVE SPRING

a.
C397884

Check that the spring length is within specification.

Spring length:

50 - 55 mm (1.97 - 2.17 in.)


If the spring is not within specification, replace it.


Hide 4. IF NECESSARY, REPLACE ROTOR SHAFT BEARING

a.
C397885

Using 2 screwdrivers, remove the snap ring.


b.
C397886

Using a press, press out the bearing.


c.
C397887

Using a press, press in a new bearing.

NOTICE:

Be careful not to scratch the rotor shaft contact surface with oil seal bearing.



d.
C397888

Install the snap ring.


Hide 5. IF NECESSARY, REPLACE OIL SEAL

a.
C397889

Using a screwdriver, remove the oil seal.

NOTICE:

Be careful not to scratch the housing with the screwdriver.



b.
C397890

Apply MP grease to the lip and outside of a new oil seal.


c.

Using SST and a press, press in the oil seal to the front housing.

NOTICE:

Ba careful not to scratch the frictional surface of the front housing.


SST
09630-24014  (09620-24021)