Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 1HZ)
RM2850E _55 Steering _073197 POWER ASSIST SYSTEMS _0356232 VANE PUMP(for 1HZ) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1HZ)  REASSEMBLY  


PROCEDURE

Hide 1. COAT POWER STEERING FLUID ON EACH PART

Hide 2.INSTALL ROTOR SHAFT

a.
C397891

Using SST and a press, press in the rotor shaft to the front housing.

SST
09632-36010  

NOTICE:

Be careful not to scratch the oil seal lip and the rotor frictional surface.



b.
C397892

Using snap ring pliers, install the snap ring.


Hide 3.INSTALL CAM RING

a.
C397893

Install a new O-ring.


b.

Install the straight pin to the front housing.


c.

Install the cam ring with the inscribed mark facing upper side.


Hide 4.INSTALL ROTOR

a.
C397894

Install the rotor with the inscribed mark facing lower side.


Hide 5.INSTALL VANE PLATES

a.
C397895

Install the 10 vane plates with the round end facing outward.


Hide 6.INSTALL PRESSURE PLATE AND SPRING

a.
C397896

Align the cut portion of the pressure plate to the straight pin and install it.


b.

Place the spring on the pressure plate.


Hide 7.INSTALL REAR HOUSING

a.
C397897

Coat a new O-ring with power steering fluid.


b.

Install the O-ring to the rear housing.


c.
C397898

Align the matchmarks on the front and rear housing and assemble them.


d.
C397899

Torque the 3 bolts.

Torque:

42 N*m (425 kgf*cm, 31 ft.*lbf)



Hide 8.INSTALL FLOW CONTROL VALVE, SPRING AND VALVE LOCK SCREW

a.
C397900

Coat power steering fluid to a new O-ring.


b.

Install the O-ring to the valve lock screw.


c.

Install the flow control valve and the spring.


d.

Install the valve lock screw.

Torque:

64 N*m (650 kgf*cm, 47 ft.*lbf)



Hide 9.CHECK ROTOR SHAFT ROTATION CONDITION

a.
C397901

Check that the rotor shaft rotates smoothly without abnormal noise.


b.

Temporarily install the gear lock nut and check the rotating torque.

Rotation torque:

0.2 N*m (2.0 kgf*cm, 1.7 in.*lbf) or less



Hide 10.INSTALL DRIVE GEAR

a.
C397902

Install the gear and woodruff key.


b.

While holding the gear with a vise, install the lock nut.

HINT:

Place the workshop rag over the gear to prevent damaging it.


Torque:

74 N*m (750 kgf*cm, 54 ft.*lbf)