Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR
RM2850E _55 Steering _073199 STEERING GEAR / LINKAGE _0356236 STEERING GEAR G

STEERING GEAR / LINKAGE  STEERING GEAR  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

When using a vice, do not over tighten it.


PROCEDURE

Hide 1.INSPECT BALL CLEARANCE

a.
C398020

Using a dial indicator, check the ball clearance by moving the power piston backward and forward.

Maximum clearance:

0.05 mm (0.0020 in.)


If necessary, replace the power piston sub-assembly.


Hide 45357 2.INSPECT SECTOR SHAFT ADJUSTING SCREW THRUST CLEARANCE

a.
C398021

Using a dial indicator, measure the thrust clearance.

Maximum clearance:

0.15 mm (0.0059 in.)


f the clearance exceed the standard, adjust sector shaft thrust clearance.


Hide 3.INSPECT GEAR HOUSING BEARING

a.
C398022

Check the needle roller bearing rotation condition and check for abnormal noise.

If the bearing is worm or damaged, replace the gear housing.


Hide 4.INSPECT SECTOR SHAFT SIDE COVER BEARING

a.
C398023

Check the needle roller bearing rotation condition and check for abnormal noise.

If the bearing is worm or damaged, replace the sector shaft side cover.