1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
2.REMOVE FRONT WHEEL
3.REMOVE NO. 1 ENGINE UNDER COVER
45047
4.DISCONNECT TIE ROD END SUB-ASSEMBLY LH
Remove the cotter pin and nut.
Using SST, disconnect the tie rod end sub-assembly LH.
45046
5.DISCONNECT TIE ROD END SUB-ASSEMBLY RH
Use the same procedure as for the LH side.
45700
6.REMOVE STEERING DAMPER ASSEMBLY
Remove the 2 nuts.
Using SST, disconnect the steering damper assembly from the steering damper bracket.
Remove the 2 bolts and steering damper bracket.
Using SST, remove the steering damper assembly from the steering idler arm assembly.
45450
7.REMOVE STEERING RELAY ROD ASSEMBLY
Remove the cotter pin and nut from the steering idler arm assembly.
Using SST, disconnect the steering relay rod assembly from the steering idler arm assembly.
To prevent the assembly from dropping, temporarily install the nut.
Remove the cotter pin and nut from the steering center arm.
Using SST, disconnect the steering relay rod assembly from the steering center arm.
Do not drop the steering relay rod assembly.
Pull out the steering relay rod assembly from the vehicle.
45440
8.DISCONNECT STEERING DRAG LINK ASSEMBLY
Remove the cotter pin and nut from the pitman arm.
Using SST, disconnect the steering drag link assembly from the pitman arm.
To prevent the assembly from dropping, temporarily install the nut.
45410
9.REMOVE CENTER ARM BRACKET ASSEMBLY
Remove the 6 bolts and center arm bracket assembly.
45070
10.REMOVE IDLER ARM BRACKET ASSEMBLY
Remove the 4 bolts and idler arm bracket assembly.