Home › Engine / Hybrid System › 1BZ-FPE (ENGINE MECHANICAL) › IGNITION TIMING › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073200 1BZ-FPE ENGINE MECHANICAL _0356242 IGNITION TIMING G

1BZ-FPE ENGINE MECHANICAL  IGNITION TIMING  INSPECTION  


PROCEDURE

Hide 1.WARM UP ENGINE

a.

Allow the engine to warm up to normal operating temperature.


Hide 2.CONNECT TACHOMETER

a.
A422191

Connect the test probe of the tachometer to terminal IG(-) of the check connector.

NOTICE:
·

Never allow the tachometer terminal to touch ground as it could result in damage to the igniter and/or ignition coil.

·

As some tachometers are not compatible with this ignition system, we recommend that you confirm the compatibility of your unit before use.




Hide 3.CONNECT TIMING LIGHT TO ENGINE

a.

Connect the tester probe of a timing light to the No. 1 high-tension cord.


Hide 4.INSPECT IGNITION TIMING

a.
A422192

Using SST, connect terminals TE1 and E1 of the check connector.

SST
09843-18020  


b.

Using a timing light, check the ignition timing.

Ignition timing:

12+/-2° BTDC @ idle

(Transmission in neutral position)


If necessary, loosen the distributor bolt and turn the distributor to align the marks. Recheck the timing after tightening the distributor bolt.

Torque:

18.5 N*m (189 kgf*cm, 14 ft*lbf)



c.

Remove the SST from the check connector, and check the ignition timing.

Ignition timing:

12+/-5° BTDC @ idle

(Transmission in neutral position)



Hide 5.DISCONNECT TIMING LIGHT FROM ENGINE

Hide 6.DISCONNECT TACHOMETER FROM ENGINE