Home › Engine / Hybrid System › 1BZ-FPE (ENGINE MECHANICAL) › TIMING GEAR › 2017.01–2021.01
RM2850E _51 Engine / Hybrid System _073200 1BZ-FPE ENGINE MECHANICAL _0356244 TIMING GEAR A

1BZ-FPE ENGINE MECHANICAL  TIMING GEAR  REPLACEMENT  


PROCEDURE

Hide 13511 1.REMOVE CAMSHAFT

a.
A423636

Using SST, remove the bolt and plate washer.

SST
09960-10010  (09962-01000, 09963-01000)


b.
A423637

Using a 19 mm socket wrench and press, press out the camshaft.


Hide 13511 2.INSTALL NEW CAMSHAFT

a.
A423638

Install the timing gear set key to the camshaft.


b.

Assembly the camshaft, thrust plate and timing gear as shown.


c.
A423639

Using a 29 mm socket wrench and press, align the timing gear set key with the key groove of the timing gear, and press in the camshaft timing gear.


d.
A423640

Using SST, install the plate washer and bolt. Torque the bolt.

SST
09960-10010  (09962-01000, 09963-01000)

Torque:

37.5 N*m (382 kgf*cm, 28 ft*lbf)



Hide 3. CAMSHAFT THRUST CLEARANCE

(Click here @@-@@)

Standard thrust clearance:

0.060 - 0.130 mm (0.0024 - 0.0051 in.)


Maximum thrust clearance:

0.30 mm (0.0118 in.)


HINT:

There are 2 methods (A and B) to replace the oil seal as follows:


Hide 13411 4.REPLACE CRANKSHAFT FRONT OIL SEAL

a.
A423641

If timing gear cover is removed from cylinder block:

i.

Using a screwdriver and hammer, tap out the oil seal.


ii.
A423642

Using a SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

SST
09223-46011  


iii.

Apply MP grease to the oil seal lip.



b.
A423643

If timing gear cover is installed to the cylinder block:

i.

Using SST, and a socket wrench remove the oil seal.

SST
09308-10010  


ii.

Apply MP grease to a new oil seal lip.


iii.
A423644

Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.

SST
09223-46011